
STC-GE Series
Product Specifications 6 Rev 3.01
Mechanical
Specifications
35 (W) x 35 (H) x 50.6 (D) mm excluding connectors
Positional accuracy in H and V directions: +/- 0.3 mm
Rotational accuracy of H and V: +/- 1.5 deg.
RJ45 connector
Power/IO connector: HR10A-7R-6PB (Hirose) or equivalent
DC IRIS lens connector: M1951 (EMUDEN) or equivalent
Two 1/4” Tripod screw holes: (One on each top and bottom plate),
Twelve M4 screws holes: (Four on each top and bottom plate, two on each side plate)
Environmental
Specifications
Environmental Temperature -5⁰C
Camera housing temperature (top plate) shall not exceed 65⁰C
(This corresponds to an environmental temperature of approximately 35⁰C)
Environmental Temperature -30⁰C to 65⁰C
20Hz to 200Hz to 20Hz (5min./cycle), acceleration 10G, 3 directions 30 min. each
Acceleration 38G, half amplitude 6ms, 3 directions 3 times each
EMS: EN61000-6-2, EMI: EN55011
Note: Please use this camera in surrounding temperature conditions that are less than 35⁰C or in conditions where the
camera’s top case plate is less than 65⁰C.
When the camera is used in surrounding temperatures that exceed 35⁰C, please make sure that the camera is set
up to properly radiate heat (maintaining the camera’s top case plate’s temperature to be less than 65⁰C).
Taking these steps will maintain the heat rating of the electronic components of the camera.
Comentarios a estos manuales