SenTech STC-400 SeriesL Especificaciones descargar pdf (Pagina 17)

Sentech STC-400 Series Application Manual

Toll Free (877) 736-8324 • Fax (972) 446-0056 • www.SentechAmerica.com

SEN

TECH

CCD SPECTRUM RESPONSE CURVE

OPTIONAL COMPONENTS AND USE

IR Cut Filter

When the camera is aimed toward a strong light source such as sun or fluorescent light, usually vertical smear appears in the

screen. This is a typical phenomenon of interline transfer type CCD. IR cut filter is an effective device to reduce this smear. IR

cut filter built-in models are also available.

Power Connector

The mating connector for “12-pin connector for power and control signal” (Hirose: HR10A-10P-12S) is available as an optional

part. Please wire all necessary connections according to 6-2.

Pre-Wired Power Connector

The above mating connector with pre-wired cables is also available as an optional

part. This makes connection works to external devices easier.

Tripod Adapter (TP-300)

For the easy camera installation, an optional adapter with 1/4" 20 UNC screw

thread hole is available. With this adapter, the camera can be installed to standard

tripod or other standard camera mounts.

Notes:

1. Requires four (4) each M2 screws to mount the TP-300 to the bottom of the

camera. (comes with TP-300 when purchased through Sentech)

2. Maximum length of the four screws must be 7mm

1 2 ... 12 13 14 15 16 17 18 19 20

Sin comentarios

SenTech STC-400 SeriesL Especificaciones Pagina 17