SenTech STC-400 SeriesL Especificaciones descargar pdf (Pagina 9)

Sentech STC-400 Series Application Manual

Toll Free (877) 736-8324 • Fax (972) 446-0056 • www.SentechAmerica.com

SEN

TECH

(2) Rear Panel (continued)

(A) 12-Pin Connector for Power and Control Signals

Connector for power, external sync signals, and video output. This connector is usually connected to power supply, sync signal generator

(or sync source), and video monitor. Please see below for the 12-pin connector’s pin assignments.

(B) Manual Gain Control Adjustment

When the Gain Select Switch is in the “Manual” mode, this gain of the video amplifier is adjusted by turning this adjustment. The user

can adjust the gain of the camera from 0 to 25 dB as desired.

Manual gain mode is selected by setting this switch to the left. Fixed gain is selected by setting this switch to the right (factory setting

default). Manual gain value is set by the (B) “Manual Gain Control Adjustment” (see above).

(D) Video Output Connector (BNC)

Video signal output connector for the camera’s composite monochrome signal.

(3) 12-Pin Connector Pin-Out

Pin No. Internal Sync External Sync

1 GND GND

2 +12Vdc +12Vdc

3 Video GND Video GND

4 Video Out Video Out

5 HD GND HD GND

6 HD Out HD In

7 VD Out VD In

8 Clock GND Clock GND

9 Clock Out Clock Out

10 GND GND

11 +12Vdc +12Vdc

12 VD GND VD GND

Note: The mating connector is the Hirose HR10A-10P-12S

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 19 20

Sin comentarios

SenTech STC-400 SeriesL Especificaciones Pagina 9